Camry L4-2.4L (2AZ-FE) (2005)
g) Aligning the matchmarks, install the inboard joint assembly to the outboard joint shaft assembly.
41. INSTALL FR AXLE INBOARD JOINT BOOT
a) Install the inboard joint boot to the inboard joint assembly.
42. INSTALL FRONT AXLE INBOARD JOINT BOOT LH NO.2 CLAMP
a) 2AZ-FE Engine: Claw Engagement
1) Using pliers, install the inboard joint boot LH No.2 clamp, as shown in the illustration.
b) 1MZ-FE, 3MZ-FE Engine: Omega Clamp Type Install new inboard joint boot clamps.
1) Hold the drive shaft lightly in a soft vise.
2) Install new 2 inboard joint boot clamps to the boot.
3) Place SST onto the inboard joint boot LH No.2 clamp.
SST 09521-24010
4) Tighten the SST so that the inboard joint boot LH No.2 clamp is pinched.
NOTICE: Do not overtighten the SST.