Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Using a screwdriver disengage the 4 clips as shown in the illustration and remove the front door inner glass weatherstrip from the front door trim
board.
7. Inspect for loose energy absorption pad cover.
NOTE
If energy absorption pad cover is not loose, STOR This TSB does NOT apply. Continue with normal diagnostic procedures for unidentified
interior noise. Follow steps 12 - 19 to reassemble the vehicle.
8. Remove remaining adhesive from the energy absorption pad and cover.
9. Scuff the energy absorption pad surface.