Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-2967030.png)
(a) Using a screwdriver, disengage the 2 claws labeled A and 2 claws labeled B from the vehicle body.
HINT: Tape the screwdriver tip before use.
(b) Using a screwdriver, disengage the 2 claws labeled C and remove the spot light assembly from the headlining.
HINT: Tape the screwdriver tip before use.
(c) Using a screwdriver, disengage the 4 claws.
HINT: Tape the screwdriver tip before use.
(d) Pull the light bulb holder in the direction indicated by the arrow in the illustration to detach the claw. Then remove the spot light assembly
from the light bulb holder.
55. REMOVE SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof)
(a) Remove the sun roof opening trim moulding.
56. REMOVE ROOF HEADLINING ASSEMBLY (w/o Sliding Roof)
(a) Disconnect the No. 1 roof wire connector and disengage each clamp from the front pillar LH.
(b) Remove the bolt and disconnect the radio setting condenser from the front pillar RH.
(c) Disconnect the antenna cord sub-assembly connector and disengage each clamp from the front pillar RH.
(d) Disconnect the antenna cord sub-assembly connector and disengage the clamp from the rear pillar RH.
(e) Disengage the 4 clips.
