Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-2967053.png)
HINT: If the rivet cannot be cut, pull it once and cut it.
17. INSTALL ROOF HEADLINING ASSEMBLY (w/o Sliding Roof)
(a) Pull the roof headlining assembly into the vehicle through the rear left door.
(b) Engage the 4 clips.
(c) Connect the antenna cord sub-assembly connector and engage the clamp to the rear pillar RH.
(d) Connect the antenna cord sub-assembly connector and engage each clamp to the front pillar RH.
(e) Install the radio setting condenser to the front pillar RH with the bolt.
(f) Connect the No. 1 roof wire connector and engage each clamp to the front pillar LH.
18. INSTALL ROOF HEADLINING ASSEMBLY (w/ Sliding Roof)
