Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
I.
Install the rear anti-squeal shim kit.
a.
Apply disc brake grease to the inside of the anti-squeal shims.
NOTE:
^
When replacing worn pads, the anti-squeal shims MUST be replaced together with the pads.
^
If pads are worn out, then inspect anti-squeal shims for heat discoloration.
^
Apply disc brake grease to the area that contacts the anti-squeal shim.
^
Disc brake grease can come out slightly from the area where the anti-squeal shim is installed.
^
Make sure that disc brake grease is NOT applied onto the lining surface.
b.
Install the 2 anti-squeal shims and the pad wear indicators to each of the 2 brake pads.
NOTE:
Install the pad wear indicator and anti-squeal shims in the correct positions.
c.
Apply a small amount of the disc brake grease (1 - 2 mm [0.04-0.08 in.] thick) to the areas shown in the illustration.
NOTE:
Do NOT apply grease to the friction surfaces of the brake pads or the disc rotor.
J.
Install the 2 rear disc brake pads with anti-squeal shim kit.
K.
Install the rear disc brake caliper assembly with the 2 bolts.
Torque: 62 N.m (630 kgf.cm, 46 ft.lbf)
NOTE:
Do NOT twist the brake hose when installing the rear disc brake caliper assemblies.
L.
Install the rear wheel.
3.
Road test the vehicle to confirm the condition has been corrected.