Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
NOTICE: Make sure that the connector is locked securely.
(d) Temporarily tighten each brake line to the correct positions of the brake actuator with No. 1 brake actuator bracket as shown in the illustration.
HINT:
-
*1: To Front Wheel Cylinder RH
-
*2: To Front Wheel Cylinder LH
-
*3: To Rear Wheel Cylinder RH
-
*4: To Rear Wheel Cylinder LH
-
*5: From Master Cylinder
-
*6: From Stroke Simulator Cylinder
(e) Using SST, fully tighten each brake line.
SST: 09023-00101
without SST - Torque: 15 Nm (155 kgf-cm, 11ft-lbf)
with SST - Torque: 14 Nm (143 kgf-cm, 10ft-lbf)
NOTICE:
-
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
-
This torque value is effective when SST is parallel to a torque wrench.
(f) Connect the brake actuator hose to the brake actuator and move the clip.
3. INSTALL COOLER BRACKET