toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Components|Page 2887 > < Components|Page 2885
Page 8
background image

(d) Install the 2 engine wires with the 2 bolts.

Torque: 8.4 Nm (86 kgf-cm, 74in-lbf)

17. INSTALL NO. 2 VENTILATION HOSE
18. INSTALL VENTILATION HOSE
19. INSTALL IGNITION COIL ASSEMBLY

(a) Install the 4 ignition coils with the 4 bolts.

Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)

20. INSTALL IDLER PULLEY BRACKET See: Service and Repair/Removal and Replacement/Installation
21. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY See: Service and Repair/Removal and Replacement/Installation
22. INSTALL V-RIBBED BELT See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and Repair/Installation
23. INSTALL V-RIBBED BELT TENSIONER COVER SUB-ASSEMBLY See: Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service

and Repair/Installation

24. INSTALL NO. 2 ENGINE MOUNTING BRACKET RH See: Service and Repair/Removal and Replacement/Installation
25. INSTALL ENGINE MOVING CONTROL ROD SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Installation
26. INSTALL NO. 2 ENGINE MOUNTING STAY RH See: Service and Repair/Removal and Replacement/Installation
27. INSTALL FRONT EXHAUST PIPE ASSEMBLY

HINT:

 See: Exhaust System/Exhaust Pipe/Service and Repair/Installation.

28. ADD ENGINE OIL
29. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL See: Service and Repair/Removal and Replacement/Installation
30. INSTALL LUGGAGE TRIM SERVICE HOLE COVER
31. CHECK FOR ENGINE OIL LEAKS
32. CHECK FOR EXHAUST GAS LEAKS
33. CHECK IGNITION TIMING See: Testing and Inspection/Component Tests and General Diagnostics/Engine
34. INSTALL FRONT FENDER APRON SEAL RH
35. INSTALL ENGINE UNDER COVER LH
36. INSTALL ENGINE UNDER COVER RH
37. INSTALL FRONT WHEEL RH
38. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY See: Service and Repair/Removal and Replacement/Installation
39. PERFORM INITIALIZATION

(a) Perform initialization procedure See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.

HINT:  Some vehicle systems require initialization after reconnecting the cable to the negative battery terminal.

From 10-2006

2AZ-FXE ENGINE MECHANICAL: TIMING CHAIN: INSTALLATION

INSTALLATION

1. INSTALL NO. 2 CHAIN SUB-ASSEMBLY

Components|Page 2887 > < Components|Page 2885