Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-913004.png)
13. REMOVE WATER PUMP PULLEY
(a) Using SST, remove the 4 bolts and water pump pulley.
SST: 09960-10010
09962-01000
09963-00700
14. REMOVE WATER PUMP ASSEMBLY
(a) Remove the clamp of the crankshaft position sensor from the water pump.
(b) Disconnect the wire of the crankshaft position sensor from the clamp bracket.
(c) Remove the 4 bolts, 2 nuts and clamp bracket.
(d) Using a screwdriver, pry between the water pump and cylinder block, and then remove the water pump.
HINT: Tape the screwdriver tip before use.
NOTICE: Be careful not to damage the contact surfaces of the water pump and cylinder block.
From 03-2006 to 10-2006
2AZ-FXE COOLING: WATER PUMP: INSTALLATION
INSTALLATION
1. INSTALL WATER PUMP ASSEMBLY
(a) Remove any old seal packing material from the contact surface.
