Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-1047016.png)
(a) Connect the generator cable. Tighten bolt B and insert the generator cable into the inverter with converter assembly.
Torque: 8.0 Nm (82 kgf-cm, 71in-lbf)
CAUTION: Wear insulating gloves.
-
Tightening bolts A and B in a wrong order may cause the cable and the inverter with converter to break.
-
Make sure that the tightening torque is between 6.4 and 9.6 N*m (65 and 98 kgf*cm).
(b) Fix the generator cable to the inverter with converter assembly with 2 bolts A.
Torque: 8.0 Nm (82 kgf-cm, 71in-lbf)
CAUTION: Wear insulating gloves.
NOTICE:
-
Tightening bolts A and B in a wrong order may cause the cable and the inverter with converter to break.
-
Make sure that the tightening torque is between 6.4 and 9.6 N*m (65 and 98 kgf*cm).
(c) Connect the wire harness clamp.
10. CONNECT MOTOR CABLE
(a) Connect the motor cable. Tighten bolt B and insert the motor cable into the inverter with converter assembly.
Torque: 8.0 Nm (82 kgf-cm, 71in-lbf)
CAUTION: Wear insulating gloves.
-
Tightening bolts A and B in a wrong order may cause the cable and the inverter with converter to break.
-
Make sure that the tightening torque is between 6.4 and 9.6 N*m (65 and 98 kgf*cm).
(b) Fix the motor cable to the inverter with converter assembly with 2 bolts A.
Torque: 8.0 Nm (82 kgf-cm, 71in-lbf)
CAUTION: Wear insulating gloves.
NOTICE:
-
Tightening bolts A and B in a wrong order may cause the cable and the inverter with converter to break.
-
Make sure that the tightening torque is between 6.4 and 9.6 N*m (65 and 98 kgf*cm).
(c) Connect the wire harness clamp.
11. INSTALL AIR CLEANER CASE SUB-ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Installation
12. INSTALL AIR CLEANER CAP SUB-ASSEMBLY See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and
Repair/Installation
13. INSTALL AIR CLEANER INLET ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Installation
14. INSTALL SERVICE PLUG GRIP See: Battery System, Hybrid Drive/Battery, Hybrid Drive/Service and Repair/HV Battery/Installation
15. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
16. INSTALL LUGGAGE TRIM SERVICE HOLE COVER See: Battery System, Hybrid Drive/Battery, Hybrid Drive/Service and Repair/HV
