Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
From 03-2006 to 10-2006
TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY
(a) Connect the connector to the tire pressure warning receiver assembly.
(b) Install the tire pressure warning receiver assembly with the bolt.
Torque: 7.5 Nm (77 kgf-cm, 66in-lbf)
2. INSTALL INNER ROOF SIDE GARNISH LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining/Installation
3. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
Assembly/Installation
4. INSTALL REAR SEAT CUSHION ASSEMBLY See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
Assembly/Installation
5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
6. PERFORM INITIALIZATION
NOTICE: Some systems need initialization after reconnecting the cable to the negative battery terminal See: Testing and
Inspection/Programming and Relearning/Repair Instruction - Initialization.
7. INSPECT TIRE PRESSURE WARNING SYSTEM
HINT: See: Tire Monitoring System/Testing and Inspection/Initial Inspection and Diagnostic Overview/Tire Pressure Warning System/Test
Mode Procedure
From 10-2006
TIRE AND WHEEL: TIRE PRESSURE WARNING RECEIVER (w/ Antenna): INSTALLATION
INSTALLATION
1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY
(a) Connect the connector to the tire pressure warning receiver assembly.
(b) Install the tire pressure warning receiver assembly with the bolt.
Torque: 7.5 Nm (77 kgf-cm, 66in-lbf)
2. INSTALL INNER ROOF SIDE GARNISH LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining/Installation
3. INSTALL REAR SIDE SEAT BACK ASSEMBLY LH See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat