Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Wheel Bearing: Testing and Inspection
Rear Axle Hub and Bearing
From 03-2006 to 10-2006
AXLE: REAR AXLE HUB AND BEARING: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY See: Steering and Suspension/Suspension/Rear Knuckle/Service and Repair/Removal
3. REMOVE REAR DISC See: Brakes and Traction Control/Parking Brake System/Service and Repair/Overhaul/Disassembly
4. INSPECT REAR AXLE HUB BEARING LOOSENESS
(a) Using a dial indicator, check for looseness near the center of the axle hub.
Maximum:
0.05 mm (0.0020 in.)
NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface.
If looseness exceeds the maximum, replace the axle hub assembly.
5. INSPECT REAR AXLE HUB RUNOUT
(a) Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum:
0.07 mm (0.0027 in.)
NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface.
If runout exceeds the maximum, replace the axle hub assembly.
6. INSTALL REAR DISC See: Brakes and Traction Control/Parking Brake System/Service and Repair/Overhaul/Reassembly
7. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY See: Steering and Suspension/Suspension/Rear Knuckle/Service and Repair/Installation
8. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76ft-lbf)
From 10-2006
AXLE: REAR AXLE HUB AND BEARING: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY See: Steering and Suspension/Suspension/Rear Knuckle/Service and Repair/Removal
3. REMOVE REAR DISC See: Brakes and Traction Control/Parking Brake System/Service and Repair/Overhaul/Disassembly
4. INSPECT REAR AXLE HUB BEARING LOOSENESS