Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-1354010.png)
(a) Reconnect CAN main bus wire connector E43 to the No. 1 CAN J/C "B" side (without earth terminal).
(b) Disconnect combination meter connector F1.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
OK -- REPLACE COMBINATION METER
NG -- REPLACE CAN BUS MAIN WIRE OR CONNECTOR (NO. 1 CAN J/C - COMBINATION METER)
Short in CAN Bus Lines
CAN COMMUNICATION: CAN COMMUNICATION SYSTEM: Short in CAN Bus Lines
Short in CAN Bus Lines
DESCRIPTION
The CAN bus wires are considered to be shorted when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is below 54 Ohms.
WIRING DIAGRAM
