Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-2693009.png)
(a) Firmly insert the holder (with connectors) into the center airbag sensor assembly until it cannot be pushed any further.
(b) Push the lever to connect the holder (with connectors). (When locking, a click sound can be heard.)
HINT: The holder slides into the center airbag sensor assembly when it is being connected. Be sure not to hold the holder while connecting,
as it may result in an insecure fit.
12. DISCONNECTION OF CONNECTOR FOR FRONT AIRBAG SENSOR
(a) Push down the housing lock (white part) and slide the CPA (yellow part). (At this time, the connector cannot be disconnected yet.)
(b) Push down the housing lock (white part) again and disconnect the connector.
HINT: Do not push down the A part shown in the illustration when disconnecting.
(c) After disconnecting the connector, check that the position of the housing lock (white part) is as shown in the illustration.
13. CONNECTION OF CONNECTOR FOR FRONT AIRBAG SENSOR
(a) Before connecting the connectors, check that the position of the housing lock (white part) is as shown in the illustration.
