Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Brake Light Switch: Testing and Inspection
Stop Light Switch
On-Vehicle Inspection
BRAKE: STOP LIGHT SWITCH: ON-VEHICLE INSPECTION
ON-VEHICLE INSPECTION
1. INSPECT STOP LIGHT SWITCH
(a) Check the protrusion of the rod.
Protrusion of the rod:
1.5 to 2.5 mm (0.059 to 0.098 in.)
NOTICE: Do not depress the brake pedal.
If the protrusion is not within the specified range, adjust it.
Brake
BRAKE: STOP LIGHT SWITCH: INSPECTION
INSPECTION
1. INSPECT STOP LIGHT SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard resistance:
If the measurement result is not normal, replace the stop light switch assembly.
Lighting
LIGHTING: STOP LIGHT SWITCH: INSPECTION
INSPECTION
1. INSPECT STOP LIGHT SWITCH ASSEMBLY