toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Front Airbag Sensor|Page 1645 > < Front Airbag Sensor|Page 1643
Page 3
background image

(a) Remove the bolt and side airbag sensor from the body.
(b) Disconnect the connector from the side airbag sensor.

NOTICE:  When handling the airbag connector, take care not to damage the airbag wire harness.

From 03-2006 to 10-2006

SUPPLEMENTAL RESTRAINT SYSTEM: SIDE AIRBAG SENSOR: INSTALLATION

INSTALLATION

1. INSTALL SIDE AIRBAG SENSOR

(a) Check that the power switch is turned off.
(b) Check that the battery negative (-) cable is disconnected.

CAUTION:  Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.

(c) Install the side airbag sensor with the bolt.

Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)

NOTICE:
-

If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a
new one.

-

When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between
other parts.

(d) Check that there is no looseness in the installation parts of the side airbag sensor.
(e) Connect the connector.

NOTICE:  When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL LOWER CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof

Headlining/Installation

3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
5. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof

Headlining/Installation

6. INSTALL FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof

Headlining/Installation

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. PERFORM INITIALIZATION

(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.

NOTICE:  Some systems need initialization after reconnecting the cable to the negative battery terminal.

9. INSPECT SRS WARNING LIGHT

(a) Inspect the SRS warning light See: Restraint Systems/Air Bag Systems/Testing and Inspection/Initial Inspection and Diagnostic

Front Airbag Sensor|Page 1645 > < Front Airbag Sensor|Page 1643