Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
(f) Install the front coil spring upper seat with the mark facing to the outside of the vehicle.
HINT: Any misalignment between the front shock absorber lower bracket and the matchmark must be +-5°.
(g) Install a new front suspension support bearing as shown in the illustration.
HINT: If there is foreign matter inside the front suspension support bearing, replace it with a new one.
(h) Install the front suspension support sub-assembly.
Temporarily tighten a new lock nut.
NOTICE: Check that the flats on the piston rod and the flats on the front suspension support sub-assembly are aligned.
(i) Remove the SST slowly in order to release the coil spring.
NOTICE: Do not use an impact wrench.