Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
21. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH (for TMMK Made) See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for TMMK Made)(From
10-2006)/Installation
22. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
(a) Install the shift lever knob sub-assembly.
23. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for TMC Made) See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for TMC Made)(From 10-2006)/Installation
24. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (for TMMK Made) See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for TMMK Made)(From 10-2006)/Installation
25. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMC Made) See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for TMC Made)(From 10-2006)/Installation
26. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (for TMMK Made) See: Body and Frame/Interior Moulding / Trim/Dashboard
/ Instrument Panel/Service and Repair/Removal and Replacement/Instrument Panel Safety Pad (for TMMK Made)(From 10-2006)/Installation
27. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining/Installation
28. INSTALL FRONT DOOR SCUFF PLATE LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Roof
Headlining/Installation
29. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48in-lbf)
30. INSPECT SHIFT LEVER POSITION See: Adjustments
31. ADJUST SHIFT LEVER POSITION See: Adjustments
32. ADJUST TRANSMISSION CONTROL CABLE ASSEMBLY See: Shift Linkage/Shift Cable/Adjustments
33. INSPECT SHIFT LEVER OPERATION See: Adjustments
34. PERFORM INITIALIZATION
(a) Perform initialization See: Testing and Inspection/Programming and Relearning/Repair Instruction - Initialization.
NOTICE: Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.