Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Wheel Bearing: Testing and Inspection
Front Axle Hub
FRONT AXLE HUB
ON-VEHICLE INSPECTION
1. REMOVE FRONT WHEEL
2. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY
3. REMOVE FRONT DISC
4. INSPECT FRONT AXLE HUB BEARING LOOSENESS
(a)
Using a dial indicator, check for looseness near the center of the axle hub.
Maximum: 0.05 mm (0.0020 inch)
NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface.
HINT: If runout exceeds the maximum, replace the axle hub.
5. INSPECT FRONT AXLE HUB RUNOUT
(a)
Using a dial indicator, check for runout on the surface of the axle hub outside the hub bolt.
Maximum: 0.05 mm (0.0020 inch)
NOTICE: Ensure that the dial indicator is set perpendicular to the measurement surface.
HINT: If runout exceeds the maximum, replace the axle hub.
6. INSTALL FRONT DISC
7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY
8. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)