Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-1801003.png)
^
2007 or 2008 Avalon:
Suspension - Rear Suspension - "Suspension: Suspension System: Problem Symptoms Table"
^
2007 or 2008 Camry:
Suspension - Rear Suspension - "Suspension: Suspension System: Problem Symptoms Table"
^
2007 Camry HV (vehicles produced 3/06 - 10/06) / (10/06 & later):
Suspension - Rear Suspension - "Suspension: Suspension System: Problem Symptoms Table"
^
2008 Camry HV:
Suspension - Rear Suspension - "Suspension: Suspension System: Problem Symptoms Table"
^
2007 or 2008 Solara:
Suspension - Rear Suspension - "Suspension: Suspension System: Problem Symptoms Table"
B.
Proceed with troubleshooting.
Refer to TIS, applicable model and model year Repair Manual:
^
2007 or 2008 Avalon:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System:
How to Proceed With Troubleshooting"
^
2007 or 2008 Camry:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System:
How to Proceed With Troubleshooting"
^
2007 or 2008 Camry HV:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System:
How to Proceed With Troubleshooting"
^
2007 or 2008 Solara:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System:
How to Proceed With Troubleshooting"
C.
Inspect the tire.
Refer to TIS applicable model and model year Repair Manual:
^
2007 or 2008 Avalon:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System: Inspection"
^
2007 or 2008 Camry:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System: Inspection"
^
2007 Camry HV (vehicles produced 3/06 - 10/06) / (10/06 & later):
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System: Inspection"
^
2008 Camry HV:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System: Inspection"
^
2007 or 2008 Solara:
Suspension - Tire/Wheel - "Tire and Wheel: Tire and Wheel System: Inspection"
NOTE
^
The specification for tire and wheel assembly uniformity for Radial Force Variation (RFV) = 60 N (13.5 lbf).
^
When performing a tire/wheel balance, the Haweka Flange Plate Kit, or an equivalent flange kit, and the proper centering cone are
required.
4.
If the vibration condition remains after referring to the applicable diagnostics steps and/or repairs then replace both front hub assemblies.
Refer to TIS applicable model and model year Repair Manual:
