Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
Transmission Position Switch/Sensor: Service and Repair
Removal
From 03-2006 to 10-2006
P311 HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL
2. REMOVE ENGINE UNDER COVER RH
3. REMOVE ENGINE UNDER COVER LH
4. REMOVE AIR CLEANER INLET ASSEMBLY See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Removal
5. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Remove the nut from the control shaft lever.
(b) Using a screwdriver, disengage the 2 claws, and disconnect the transmission control cable assembly with the clip from the control cable
bracket.
HINT: Tape the screwdriver tip before use.
(c) Remove the clip.
6. REMOVE SHIFT LEVER POSITION SENSOR
(a) Disconnect the shift lever position sensor connector.