Camry L4-2.4L (2AZ-FXE) Hybrid (2007)
_hybrid/Page-3508009.png)
(a) Install 2 new No. 1 stoppers to the vehicle body, as shown in the illustration.
HINT: Only 2-piece type No. 1 stoppers are supplied. Use the 2-piece type stoppers even if a 1-piece type was used.
4. INSTALL WINDSHIELD MOULDING
(a) Using a brush or sponge, coat the application area of moulding with Primer G.
NOTICE:
-
Do not apply too much primer.
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not keep any of the opened Primer G for later use.
HINT: If an area other than that specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
(b) Install a new moulding onto the windshield glass, as shown in the illustration.
5. INSTALL WINDOW GLASS ADHESIVE DAM
(a) Using a brush or sponge, coat the application area of adhesive dam with Primer G.
NOTICE:
-
Do not apply too much primer.
-
Allow the primer coating to dry for 3 minutes or more.
-
Do not keep any of the opened Primer G for later use.
HINT: If an area other than that specified is coated by accident, wipe off the primer with a clean piece of cloth before it dries.
(b) Install a new adhesive dam onto the windshield glass, as shown in the illustration.
NOTICE: Install the new adhesive dam along the ceramic notches.
Standard dimension:
