toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Factory Installed Keyless Entry|Page 6431 > < Factory Installed Keyless Entry
Page 2
background image

HINT:  
- When the confirmation mode has been selected and 0 codes are registered, LOCK-UNLOCK operation is automatically performed 5

times.

- When the confirmation mode has been selected and LOCK-UNLOCK operation has been performed twice as shown in the illustration,

the number of the registered recognition codes is 2.

 

HINT:  If the prohibition mode and confirmation mode are selected, the registration mode ends.

c. Registration of transmitter:

1. Within 40 seconds after the add mode or the rewrite mode has been selected, press the LOCK and UNLOCK switches twice. 

NOTE:  Press and hold both switches for 1 second or more during each press. However, the time between the 1st press and the 2nd press
must be under 3 seconds.

2. LOCK-UNLOCK operation is automatically performed once within 3 seconds after above operation (step 1), when the recognition code of

the transmitter has been registered correctly. If the LOCK-UNLOCK operation is performed twice, the registration of the recognition code
has failed. In this case, register the recognition code from the beginning of the registration procedures once again.

3. Within 3 seconds after the transmitter switch has been turned OFF; the LOCK-UNLOCK operation will be automatically performed once

if the registration of the recognition code of the transmitter is completed correctly. In case the LOCK-UNLOCK operation is performed
twice, the registration of recognition code has failed. Perform the registration procedure from the beginning once again.

4. When continuing the registration, register the transmitter within 40 seconds after the previous registration.

HINT:  4 type recognition codes can be registered at one time.

d. If even one of the following conditions is satisfied, registration of recognition codes is completed.

1. 40 seconds have elapsed under the condition that the registration mode is ready.
2. The driver's door is opened.
3. The key plate is inserted in the ignition key cylinder.
4. 4 type recognition codes are registered at one time.

Factory Installed Keyless Entry|Page 6431 > < Factory Installed Keyless Entry