Camry V6-3.0L (1MZ-FE) (2004)
2. Remove the backing paper from a new gasket, and affix the gasket along the groove of the timing belt cover as shown in the illustration.
NOTICE:
^
Affix the gasket in the center of the groove.
^
At the corners, try to keep the gasket thickness uniform.
Length
3. If there is a gap on the joint of the gasket, apply seal packing to close the gap.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE: When applying the seal packing, apply it as wide and high as the gasket.
d. Install the timing belt cover with the 6 bolts.
Torque: 8.5 Nm (87 kgf-cm, 76 inch lbs.)
33. INSTALL CAMSHAFT TIMING PULLEY
a. Install the camshaft timing pulley with the belt guide properly oriented and tighten the bolt temporarily.
HINT:
^
Face the belt guide of the RH timing pulley towards the front of the engine.
^
Face the belt guide of the LH timing pulley towards the rear of the engine.
b. Using SST, tighten the RH pulley bolt.