Camry V6-3.0L (1MZ-FE) (2004)
Throttle Body: Service and Repair
REPLACEMENT
1. DRAIN ENGINE COOLANT
2. w/ Performance rod:
REMOVE FRONT SUSPENSION UPPER BRACE CENTER
a. Remove the 2 nuts and upper brace.
3. REMOVE V-BANK COVER SUB ASSY
a. Using a socket hexagon wrench 5, remove the 3 nuts.
b. Remove the V-bank cover.
4. REMOVE AIR CLEANER CAP SUB-ASSY
a. Disconnect the MAF meter connector.
b. Disconnect the VSV connector.
c. Remove the ventilation hose No. 2.
d. Disconnect the emission tube No. 1 fuel hose.
e. Disconnect the vacuum hoses.
f.
Remove the fuel vapor feed hose from the 2 hose clamps.
g. Loosen the air cleaner hose clamp bolt, and then remove the intake air resonator.
5. REMOVE THROTTLE BODY ASSY
a. Disconnect the throttle control motor & throttle position sensor connector.
b. Disconnect the water bypass hose No. 2.
c. Disconnect the water bypass hose No. 3.
d. Remove the 2 bolts, 2 nuts and throttle body.