Camry V6-3.0L (1MZ-FE) (2004)
g. Align the groove with neutral basic line.
h. Hold the switch in position and tighten the 2 bolts.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
i.
Using a screwdriver, stake the nut with the lock plate.
j.
Install the control shaft lever, washer and nut.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
k. Connect the park/neutral position switch connector.
11. CONNECT TRANSMISSION CONTROL CABLE ASSY
a. Temporarily install the control cable to the control shaft lever with the nut.
b. Install the control cable and a new clip to the bracket.
12. ADJUST SHIFT LEVER POSITION
13. INSPECT SHIFT LEVER POSITION
14. INSPECT PARK/NEUTRAL POSITION SWITCH ASSY
15. INSTALL ENGINE UNDER COVER NO.1
16. INSTALL INTAKE AIR RESONATOR SUB-ASSY
17. INSTALL AIR CLEANER INLET NO.1
18. INSTALL AIR CLEANER BRACKET
19. INSTALL AIR CLEANER HOSE NO.1
20. INSTALL AIR CLEANER ASSY