Camry V6-3.3L (3MZ-FE) (2005)
Compass: Testing and Inspection
PRE-CHECK
1. SELECTING COMPASS DISPLAY MODE
a. The comp switch allows you to select a Display or Non-display mode of the compass.
2. SETTING ZONE
a. Deviation between the "magnetic north" and "actual north" differs depending on the location. Therefore, adjustment of the magnetism is
required.Since the magnetic condition differs according to the area where the vehicle is used, it is necessary for each user to set the zone.(Refer
to "Compass Zone Map"). The zone setting can be changed using the comp switch of the inner mirror.
3. PERFORMING CALIBRATION
a. Because each vehicle has its own magnetic field, calibration should be performed for each vehicle.This compass function is used when storing
the record of the vehicle's magnetic field.
4. WHEN COMPASS MAGNETIZED:
a. A compass could be magnetized during shipping by vessels or freight cars. Before delivery, therefore, make sure to perform calibration and
ensure that calibration is done properly. If it cannot be done (cannot be complete in spite of driving around several times), it may be caused by
magnetization. Demagnetize the vehicle using a demagnetizer and perform calibration again.
5. SETTING COMPASS
6. ZONE SETTING MODE
a. Pressing the comp switch for 3 seconds. In the normal mode will activate the zone setting mode.A number (1 - 15) is displayed on the compass
display.
HINT: In the initial status, "8" is displayed.
b. The displayed number increases +1 every time the comp switch is pressed.Referring to the map, check the number for the area where the
vehicle will be used and set the zone number.
c. Leave it untouched for several seconds after setting and check that the compass display shows an azimuthal direction (N, NE, E, SE, S, SW,
W, or NW) or "C".
7. CALIBRATION SETTING MODE
a. Pressing the comp switch for 6 seconds. in the normal mode will also activate this mode.