Camry V6-3.3L (3MZ-FE) (2005)
Repairs and Inspections Required After a Collision: Service and Repair
Air Bag System
REPAIRS AND INSPECTIONS REQUIRED AFTER A COLLISION
ON-VEHICLE INSPECTION
CAUTION: Be sure to perform the initialization of the occupant classification ECU under the conditions listed below. If the initialization is not
performed, the SRS may not operate properly.
-
The occupant classification ECU is replaced.
-
Accessories (seatback tray or seat cover, etc. ) are installed to the vehicle.
-
The passenger seat is removed from the vehicle.
-
Both the SRS warning light and passenger airbag ON/OFF indicator light (OFF) come on.
-
The vehicle is brought to the workshop for repair purpose due to an accident or collision.
1. HORN BUTTON ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)
HINT: There are two types of horn button assembly:
One is used with 3-spoke steering wheel assembly and the other is used with 4-spoke steering wheel assembly.
a. Perform a diagnostic system check.
b. With the horn button assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the horn
button assembly with a new one: Cuts, minute cracks or marked discoloration on the horn button assembly top surface or in the grooved
portion.
2. HORN BUTTON ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS NOT DEPLOYED)
a. Perform a diagnostic system check.
b. With the horn button assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the horn
button assembly or steering wheel assembly with a new one:
-
Cuts, minute cracks or marked discoloration on the horn button assembly top surface or in the grooved portion.
-
Cracks or other damage to the connector.
-
Deformation of the steering wheel assembly.