Camry V6-3.3L (3MZ-FE) (2005)
h. Coat a new oil seal lip with power steering fluid.
i.
Using SST and a press, install the oil seal.
SST 09612-22011
NOTICE: Make sure that the oil seal is installed facing in the correct direction.
j.
Apply grease to the needle bearing.
k. Install a new gasket to the control valve housing.
l.
Wind vinyl tape around the serration part of the control valve.
m. Install the control valve housing to the rack housing with the 2 bolts.
Torque: 21 Nm (214 kgf-cm, 15 ft. lbs.)
n. Using SST, stop the control valve rotation and install a new lock nut.
Torque: 24.5 Nm (250 kgf-cm, 18 ft. lbs.)
SST 09616-00011
o. Apply sealant to 2 or 3 threads of the rack housing cap.
Sealant: Part No. 08833-00080, THREE BOND 1344, LOCTITE 242 or equivalent
p. Using a socket wrench (27 mm), install the rack housing cap.
Torque: 58.5 Nm (597 kgf-cm, 43 ft. lbs.)