Camry V6-3.3L (3MZ-FE) (2005)
b) Place SST onto the outboard joint boot LH No.2 clamp.
SST 09521-24010
c) Tighten the SST so that the outboard joint boot LH No.2 clamp is pinched.
NOTICE: Do not overtighten the SST.
d) Using SST, measure the clearance of the outboard joint boot LH No.2 clamp.
SST 09240-00020
Clearance: 0.8 mm or less (0.031 inch) or less
NOTICE: When the measured value is greater than the specified value, retighten the clamp.
37. INSTALL FRONT AXLE OUTBOARD JOINT BOOT LH CLAMP
a) The procedure for the outboard joint boot LH clamp is the same as above.
SST 09521-24010, 09240-00020
Clearance: 1.5 - 2.5 mm (0.059 - 0.098 mm)
38. INSTALL FRONT DRIVE SHAFT DAMPER LH
HINT: This procedure is unnecessary for a manual transaxle vehicle because it does not have a drive shaft damper.
a) Install the drive shaft damper LH to the drive shaft.
b) Make sure that the damper is on the shaft groove.
c) Set the distance, as shown.
Distance: 207 ±2.0 mm (8.15 ±0.079 inch)