Camry V6-3.5L (2GR-FE) (2008)
/Page-2322020.png)
HINT: Tape the screwdriver tip before use.
(b) Using a screwdriver, disengage the 2 claws [A] as shown in the illustration.
HINT: Tape the screwdriver tip before use.
(c) Disengage the 2 claws [B] and remove the No. 1 room light assembly.
(d) Disconnect the room light connector.
65. REMOVE SPOT LIGHT ASSEMBLY (w/ Sliding Roof)
(a) Using a screwdriver, disengage the 2 claws labeled A and 2 claws labeled B from the vehicle body.
HINT: Tape the screwdriver tip before use.
(b) Using a screwdriver, disengage the 2 claws labeled C and remove the spot light assembly from the headlining.
HINT: Tape the screwdriver tip before use.
(c) Using a screwdriver, disengage the 4 claws.
HINT: Tape the screwdriver tip before use.
(d) Pull the light bulb holder in the direction indicated by the arrow in the illustration to detach the claw. Then remove the spot light assembly
from the light bulb holder.
66. REMOVE SUN ROOF OPENING TRIM MOULDING (w/ Sliding Roof)
(a) Remove the sun roof opening trim moulding.
67. REMOVE SUNSHADE TRIM HOLDER (w/ Rear Sunshade)
