Camry V6-3.5L (2GR-FE) (2008)
3. Remove the two plastic reinforcements from top surface of headliner.
NOTE
Plastic reinforcements are located on the RH Rear and LH Front corners of headliner opening for both the LH and RH Visor Assembly.
4. Apply felt to the roof panel opening for visor as shown.
From the Noise Kit cut two felt strips of the following dimensions:
Length: 25 mm (1 in.)
Width: 9 mm (3/8 in.)
Thickness: 0.5 mm (0.02 in.) thinnest felt sheet material in the kit.
5. Install the front visor support
NOTE
Front and rear supports are identical