Camry V6-3.5L (2GR-FE) (2008)
REMOVAL
HINT:
-
Use the same procedures for the RH side and LH side.
-
The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH (See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release
Cable/Service and Repair/Removal)
3. REMOVE FRONT FENDER LINER (See: Body and Frame/Doors, Hood and Trunk/Hood/Hood Latch Release Cable/Service and
Repair/Removal)
4. REMOVE FRONT SPEED SENSOR
(a) Disconnect the front speed sensor connector and clamp.
(b) Remove the 2 bolts from the body and the shock absorber assembly.
(c) Disengage the 2 claws from the steering knuckle and body.
(d) Remove the bolt and the front speed sensor.
-
Prevent foreign matter from attaching to the sensor tip.
-
Clean the installation hole and the surface for the speed sensor every time the speed sensor is removed.
Installation
BRAKE CONTROL: FRONT SPEED SENSOR:
INSTALLATION
1. INSTALL FRONT SPEED SENSOR