Camry V6-3.5L (2GR-FE) (2008)
Water Pump: Service and Repair
Installation
2GR-FE COOLING: WATER PUMP:
INSTALLATION
1. INSTALL WATER PUMP ASSEMBLY
(a) Install a new water pump gasket and the water pump assembly with the 16 bolts.
Bolt A - Torque: 21 Nm (214 kgf-cm, 15 ft-lbf)
Bolts B and C - Torque: 9.1 Nm (93 kgf-cm, 81 in-lbf)
-
Make sure that there is no oil on the threads of bolts A.
-
Be sure to replace 2 bolts C with new ones or reuse them after applying adhesive 1344.
Adhesive:
Toyota Genuine Adhesive 1344, Three Bond 1344 or Equivalent
2. INSTALL WATER INLET HOUSING
(a) Install a new water inlet housing No. 1 gasket and water outlet pipe O-ring.
(b) Install the water inlet housing with the 2 bolts and nut.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
NOTE: Be careful not to allow the O-ring to get caught between the parts.
(c) Connect the water hose.
3. INSTALL WATER PUMP PULLEY
(a) Temporarily install the water pump pulley with the 4 bolts.
(b) Using SST, hold the water pump pulley.
SST: 09960-10010
09962-01000
09963-00700