Camry V6-3.5L (2GR-FE) (2008)
F. Using the SST, tighten the oil filter cap.
SST P/N: 09228-06501
Torque: 25 N.m (255 kgf.cm, 18 ft.lbf)
NOTE:
Make sure that the oil filter is installed securely as shown.
G. Apply a light coat of engine oil to a NEW O-ring and install it to the oil filter cap (P/N 96723-35028).
NOTE:
Remove all dirt and foreign matter from the installation surface.
H. Install the oil filter drain plug to the oil filter cap.
Torque: 13 N.m (130 kgf.cm, 9 ft.lbf)
NOTE:
Make sure that the O-ring does NOT get caught between the parts.
24. Install the No. 1 oil pipe.
A. Make sure that there is NO foreign matter on the mesh of the oil control valve filter LH.
NOTE:
Do NOT touch the mesh when installing the oil control valve filter.