Camry V6-3.5L (2GR-FE) (2008)
-
Remove any oil from the contact surface.
-
Install the head cover within 3 minutes after applying seal packing.
-
Do NOT start the engine for at LEAST 2 hours after installing.
B. Install 3 NEW gaskets as shown.
C. Install a NEW gasket to the head cover.
D. Install the head cover with the 12 bolts and a NEW washer.
Torque: Bolt A: 21 N.m (214 kgf.cm, 15 ft.lbf)
Torque: Except Bolt A: 10 N.m (102 kgf.cm, 7 ft.lbf)
HINT:
Reconfirm the tightening torque of bolts 1 and 10.
22. Install the crankshaft pulley.
A. Align the pulley set key with the key groove of the pulley, and slide on the pulley.