Camry V6-3.5L (2GR-FE) (2008)
/Page-789003.png)
1. Check for the Authorized Modifications Label affixed to the vehicle in the location shown in Figure 1. Confirm if the TCM calibration has been
updated. If the calibration ID listed is NOT the latest TCM calibration - go to step 2.
2. Flash reprogram the TCM.
NOTE
^
The GR8 Battery Diagnostic Station MUST be used in Power Supply Mode to maintain battery voltage at 13.5 volts while flash
reprogramming the vehicle.
^
For details on how to use the GR8 Battery Diagnostic Station, refer to the located on the Technical Information System (TIS), Diagnostics -
Battery
Follow the procedures outlined in TSB No. SS002-07, "Techstream ECU Flash Reprogramming Procedure", and flash the TCM with the NEW
calibration file update.
3. Start the engine and warm it up to normal operating temperature before test driving.
4. Test drive the vehicle to confirm proper vehicle operation and TCM initial learning.
Refer to TIS applicable model year Camry Repair Manual:
2008 / 2009 Camry:
Drivetrain - Automatic Transmission/Transaxle - "U660E Automatic Transaxle: Automatic Transaxle System: Road Test"
5. If any of the following conditions still exist check the automatic transaxle fluid and adjust if necessary.
^
Shift flare
^
Harsh Downshift on Reacceleration
^
"Jerk" feeling on Reacceleration
