Camry V6-3.5L (2GR-FE) (2008)
/Page-962033.png)
(a) Reconnect the CAN main bus wire connector (E42) to the No. 1 CAN J/C "A" side (with earth terminal).
(b) Disconnect the No. 2 CAN J/C connector (A40) (rear of the vehicle).
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
OK -- CHECK FOR SHORT TO GND IN CAN BUS WIRE (ECM MAIN BUS WIRE)
NG -- Continue to next step.
7. CHECK FOR SHORT TO GND IN CAN BUS WIRE (NO. 1 CAN J/C - NO. 2 CAN J/C)
(a) Disconnect the No. 2 CAN J/C connector (E41) (front of the vehicle).
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
