Camry V6-3.5L (2GR-FE) (2008)
Throttle Body: Service and Repair
Installation
2GR-FE ENGINE CONTROL SYSTEM: THROTTLE BODY:
INSTALLATION
1. INSTALL THROTTLE BODY
(a) Install a new throttle body gasket to the intake air surge tank.
(b) Install the throttle body with the 4 bolts.
Torque: 10 Nm (102 kgf-cm, 7 ft-lbf)
(c) Connect the 2 water by-pass hoses.
(d) Connect the throttle body connector and clamp.
2. INSTALL NO. 1 AIR CLEANER INLET (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Installation)
3. INSTALL AIR CLEANER CASE SUB-ASSEMBLY (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and
Replacement/Installation)
4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY
(a) Install the air cleaner cap sub-assembly, and connect the 3 bands.