Camry V6-3.5L (2GR-FE) (2008)
(a) Disconnect the negative battery terminal.
(b) Disconnect the positive battery terminal.
(c) Remove the engine room junction block from the engine room R/B.
(d) Measure the resistance between the terminals.
Standard resistance (Check for open):
Standard resistance (Check for short):
(e) Reinstall the engine room junction block.
(f) Reconnect the positive battery terminal.
(g) Reconnect the negative battery terminal.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
5. INSPECT ENGINE ROOM JUNCTION BLOCK (EFI RELAY)
(a) Remove the engine room junction block from the engine room R/B.
(b) Measure the resistance between the terminals.
Standard resistance:
(c) Reinstall the engine room junction block.
NG -- REPLACE ENGINE ROOM JUNCTION BLOCK
OK -- Continue to next step.