Camry V6-3.5L (2GR-FE) (2008)
Clockspring Assembly / Spiral Cable: Service and Repair
Installation
SUPPLEMENTAL RESTRAINT SYSTEM: SPIRAL CABLE:
INSTALLATION
1. INSTALL SPIRAL CABLE (w/ VSC)
(a) Engage the 6 claws and install the spiral cable to the steering angle sensor.
2. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR (w/ VSC)
(a) Check that the front wheels are facing straight ahead.
(b) Set the turn signal switch to the neutral position.
NOTE: If it is not in the neutral position, the pin of the turn signal switch may be snapped.
(c) Engage the 3 claws and install the spiral cable with steering angle sensor.
NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
(d) Connect the connectors to the spiral cable with steering angle sensor.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
3. INSTALL SPIRAL CABLE (w/o VSC)
(a) Check that the front wheels are facing straight ahead.
(b) Set the turn signal switch to the neutral position.
NOTE: If it is not in the neutral position, the pin of the turn signal switch may be snapped.
(c) Engage the 3 claws and install the spiral cable.
NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel assembly.
(d) Connect the connectors to the spiral cable.
NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
4. INSTALL STEERING COLUMN COVER (See: Steering and Suspension/Steering/Steering Column/Service and Repair/Installation)
5. ADJUST SPIRAL CABLE
(a) Check that the ignition switch is off.