Camry V6-3.5L (2GR-FE) (2008)
/Page-2118010.png)
(a) Check the degree of the tilt when the ELR begins to lock.
(1) Check that the belt does not lock at less than 15 degrees of tilt in any direction but locks at over 45 degrees of tilt while gently pulling the
belt.
NOTE: Do not disassemble the retractor.
(b) Align the claw with the seat belt positioning hole and install the rear seat inner with center belt assembly LH with the bolt.
Torque: 42 Nm (428 kgf-cm, 31 ft-lbf)
2. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY
(a) Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
(b) Engage the 4 clips and 5 claws and install the package tray trim panel assembly.
(c) Connect the connector.
3. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY (for Reclining Seat Type)
(a) Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.
(b) Engage the 4 clips and 5 claws and install the package tray trim panel assembly.
(c) Connect the connector.
4. INSTALL REAR SEAT SHOULDER BELT HOLE COVER
(a) Engage the 4 claws and install the rear seat shoulder belt hole cover.
