Camry V6-3.5L (2GR-FE) (2008)
B. Insert the support through the connector opening and attach the support hook to the edge of the roof panel opening.
C. Reposition the string or wire as indicated in Figure 9.
D. Attach felt between the support and the roof panel to hold the support in place.
From the Noise Kit cut two felt strips of the following dimensions:
Length: 25 mm (1 in.)
Width: 5 mm (3/16 in.)
Thickness: 0.5 mm (0.02 in.)
E. Remove the string or wire from the support.
7. Install the brackets into the sunvisor base.