Camry V6-3.5L (2GR-FE) (2008)
(a) Using pliers, remove the No. 2 front axle outboard joint boot clamp as shown in the illustration.
10. REMOVE FRONT AXLE OUTBOARD JOINT BOOT CLAMP
(a) Remove the front axle outboard joint boot clamp.
HINT: Perform the same procedures as for the No. 2 front axle outboard joint boot clamp.
11. REMOVE FRONT AXLE OUTBOARD JOINT BOOT
(a) Remove the outboard joint boot from the outboard joint shaft.
(b) Remove the grease from the outboard joint.
12. REMOVE FRONT DRIVE SHAFT DUST COVER LH
(a) Using SST and a press, remove the drive shaft dust cover LH.
SST: 09950-00020
NOTE: Be careful not to drop the inboard joint assembly.
13. REMOVE FRONT DRIVE SHAFT DUST COVER RH
(a) Using a press, remove the drive shaft dust cover RH.
14. REMOVE FRONT DRIVE SHAFT DUST COVER
(a) Using SST and a press, remove the drive shaft dust cover.
SST: 09950-00020
15. REMOVE FRONT DRIVE SHAFT BEARING
(a) Using a snap ring expander, remove the drive shaft hole snap ring.