Camry V6-3.5L (2GR-FE) (2008)
(a) Using SST and a press, install a new drive shaft dust cover RH until distance (A) from the tip of the center drive shaft to the drive shaft dust
cover RH meets the specification.
SST: 09527-10011
-
The dust cover should be completely installed.
-
Be careful not to damage the dust cover.
4. INSTALL FRONT DRIVE SHAFT DUST COVER LH
(a) Using SST and a press, install a new drive shaft dust cover LH.
SST: 09527-10011
-
The dust cover should be completely installed.
-
Be careful not to damage the dust cover.
5. INSTALL FRONT AXLE OUTBOARD JOINT BOOT
(a) Hold the drive shaft lightly in a vise between aluminium plates.
HINT: Before installing the boots, wrap the spline of the drive shaft with vinyl tape to prevent the boots from being damaged.
(b) Temporarily install a new outboard joint boot to the drive shaft with the 2 clamps.
(c) Coat the outboard joint shaft and boot with grease.
6. INSTALL FRONT AXLE OUTBOARD JOINT BOOT CLAMP