Camry CE Sedan V6-3.0L (1MZ-FE) (1998)
/Page-1452001.png)
Hydraulic Control Assembly - Antilock Brakes: Testing and Inspection
ABS (TMC/Denso Made)
ON-VEHICLE INSPECTION
HINT: Using the ABS actuator checker, Special Service Tool (SST) 09990-00150, 09990-00250, 09990-00300, 09990-00360 or equivalent, check
the operation of the actuator. If the actuator does not operate, check the operation of sub-wire harness G. If the solenoid and/or pump motor relay are
abnormal, replace the relay and inspect the actuator operation again.
1. Inspect battery positive voltage.
Battery positive voltage: 10 - 14 V
2. Disconnect connectors.
Disconnect the 2 connectors from the actuator.
3. Connect actuator checker (SST).
a. Connect the actuator checker (SST) to the actuator side wire harness via the sub-wire harness (SST), as shown.
b. Connect the red cable of the checker to the battery positive (+) terminal and black cable to the negative (A terminal. Connect the black cable of
the sub-wire harness to the battery negative (-) terminal or body ground.
c. Place the "SHEET P" SST 09990-00430, on the actuator checker.
4. Inspect brake actuator operation.
a. Start the engine, and run it at idle.
b. Turn the selector switch of the actuator checker to "FRONT LH" position.
c. Push and hold in the MOTOR switch for a few seconds.
