Camry CE Sedan V6-3.0L (1MZ-FE) (1998)
/Page-348007.png)
If the gasket has cracks or peeling, etc., replace it using these steps:
1) Using a screwdriver and gasket scraper, remove all the old gasket material.
2) Thoroughly clean all components to remove all the loose material.
3) Remove the backing paper from a new gasket and install the gasket evenly to the part of the timing belt cover shaded black in the
illustration.
4) After installing the gasket, press down on it so that the adhesive firmly sticks to the timing belt cover.
b. Install the timing belt cover with the 5 bolts.
Torque: 8.5 Nm (74 inch lbs.)
c. Install the engine wire protector clamp to the No.3 timing belt cover.
d. Install the engine wire protector to the No.3 timing belt cover with the bolt.
13. Install timing belt guide.
Install the timing belt guide, facing the cup side outward.
14. Install No.1 timing belt cover.
a. Check that the timing belt cover gaskets have cracks or peeling, etc.
If the gasket has cracks or peeling, etc., replace it using these steps:
1) Using a screwdriver and gasket scraper, remove all the old gasket material.
2) Thoroughly clean all components to remove all the loose material.
3) Remove the backing paper from a new gasket and install the gasket evenly to the part of the timing belt cover shaded black in the
illustration.
NOTICE: When joining 2 gaskets, do not leave a gap between them. Cut off any excess gasket.
4) After installing the gasket, press down on it so that the adhesive firmly sticks to the timing belt cover.
b. Install the timing belt cover with the 4 bolts.
Torque: 8.5 Nm (74 inch lbs.)
15. Install crankshaft pulley.
a. Align the pulley set key with the key groove of the pulleys and slide on the pulley.
