Camry CE Sedan V6-3.0L (1MZ-FE) (1998)
Right Hand Side View
a. Using a torx wrench, install the airbag sensor assembly with 3 screws.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
Torque: 20 N.m (205 kgf.cm, 15 ft.lbf)
b. Connect the airbag sensor connectors.
NOTICE:
-
Installation of the connector is done after the sensor assembly has been installed.
-
Make sure the sensor assembly is installed with the specified torque.
-
If the sensor assembly has been dropped, or there are cracks, dents or other defects in the case, bracket or connector, replace the sensor
assembly with a new one.
-
When installing the senor assembly, take care that the SRS wiring does not interfere with other parts and is not pinched between other parts.
-
After installing, shake the sensor assembly to check that there is no looseness.
2. INSTALL REMOVED PARTS
Side Airbag Sensor Assembly
REMOVAL
NOTICE: Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary. (If the IC terminals are touched, the
IC may be destroyed by static electricity.)
1. REMOVE THESE PARTS:
a. Front door scuff plate
b. Center pillar lower garnish
2. REMOVE FRONT SEAT OUTER BELT RETRACTOR
a. Disconnect the pretensioner connector.
b. Disconnect the retractor switch connector.
c. Remove the 2 bolts and retractor.
3. REMOVE SIDE AIRBAG SENSOR ASSEMBLY