Camry CE Sedan V6-3.0L (1MZ-FE) (1998)
/Page-1607005.png)
6. Using pliers, compress the snap ring.
7. Check that the snap ring fits correctly.
8. Remove the starter housing and clutch assembly from the brass bar.
9. Using a plastic-faced hammer, tap the clutch shaft and install the stop collar onto the snap ring.
2. REPLACE FRONT BEARING
a. Using SST, remove the bearing.
SST 09286-46011
b. Using SST and a press, press in a new bearing.
NOTE: Be careful of the bearing installation direction.
SST 09820-00030
3. REPLACE REAR BEARING
