Camry CE Sedan 4-Door L4-2164cc 2.2L DOHC MFI (1997)
^
The points shown in the illustration and oil cooler near here (A/T) cannot be staked with the SST. Use pliers or similar object and be
careful not to damage the core plates.
(b) Check the lock plate height (H) after completing the caulking.
Plate height: 7.40 - 7.80 mm (0.2913 - 0.3071 inch)
If not within the specified height, adjust the stopper bolt of the handle again and caulk again.
6. Install Engine Coolant Temperature (ECT) switch.
(a)
Install a new O-ring to the ECT switch.
(b) Install the ECT switch.
7. Install drain plug.
(a)
Install a new O-ring to the drain plug.
(b) Install the drain plug.
8. Inspect for water leaks.
(a)
Tighten the drain plug.
(b) Plug the inlet and outlet pipes of the radiator with SST Radiator Service Tool Set # 09230 - 01010 or equivalent.
(c)
Using a radiator cap tester, apply pressure to the radiator.
Test pressure: 177 kPa (26 psi)
(d) Submerge the radiator in water.
