toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Water Pump|Specifications|Page 2304 > < Water Pump|Specifications|Page 2302
Page 3
background image

6. Remove the A/C compressor.

7. Remove generator drive belt adjusting bar.

(a)

Disconnect the crankshaft position sensor wire from the clamp on the adjusting bar.

(b) Disconnect the crankshaft position sensor connector from the bracket on the adjusting bar.
(c)

Remove the bolt and adjusting bar.

8. Remove water pump and water pump cover assembly.

(a)

Remove the 2 nuts holding the water pump to the water bypass pipe.

(b) Remove the 3 bolts in the sequence shown.

(c)

Disconnect the water pump cover from the water bypass pipe, and remove the water pump and water pump cover assembly.

(d) Remove the gasket and 2 O-rings from the water pump and water bypass pipe.

9. Remove water pump from water pump cover.

Remove the 3 bolts, water pump and gasket.

INSTALLATION

Water Pump|Specifications|Page 2304 > < Water Pump|Specifications|Page 2302